SQ001S

LoRa Development Board

ESP32-C3 and SX1262 on a breadboard-friendly board that runs off a Li-ion cell or a small solar panel — for LoRa and LoRaWAN sensor prototypes.

Price on request

SQ001S LoRa development board

Built for off-grid sensor nodes

ESP32-C3 + SX1262

RISC-V up to 160 MHz with Wi-Fi and Bluetooth LE, plus a Semtech SX1262 LoRa radio — 863–928 MHz, up to 21 ± 1 dBm, −134 dBm sensitivity (SF12).

Solar and Li-ion power

On-board Li-ion charger with indicator LED, and a VS input that boosts a solar panel or AA / AAA cells (1–5 V) up to 5 V.

Switchable sensor power

A 3.3 V Vext rail, switched by GPIO1, powers external sensors only while you read them — the module itself sleeps at about 10 µA.

Arduino and LoRaWAN ready

Program over USB Type-C from Arduino IDE or PlatformIO. The open-source siliqs_ct62 library adds LoRaWAN (ABP and OTAA) and joins a Siliqs LD1001 gateway.

Specifications

Selected highlights — see the datasheet for the full tables and items still to be confirmed.

ModuleHT-CT62: ESP32-C3FN4 (RISC-V, 160 MHz, 4 MB flash) + SX1262
LoRa863 – 928 MHz; 21 ± 1 dBm; −134 dBm (SF12, 125 kHz)
2.4 GHzWi-Fi 802.11 b/g/n, Bluetooth LE
PowerUSB-C 5 V; Li-ion 3 – 4.2 V with charger; VS 1 – 5 V boosted to 5 V; 3.3 V switched Vext
Connectors2 × 10-pin 2.54 mm headers; 1.25 mm 4-pin I2C sensor connector; IPEX for LoRa and 2.4 GHz antennas
USBType-C with USB-to-UART bridge
Deep sleep (module)10 µA

Board and pinout

SQ001S board overview
SQ001S pinout

I2C: current firmware uses GPIO18 = SDA, GPIO19 = SCL (the pinout drawing labels them the other way round).

Downloads

Datasheet, Rev 0.1 (preliminary).

Get the SQ001S

Price and lead time on request.