② Configure 設 · Free tool

Configurator

No firmware edits — point-and-click what this node does. Set its role, Modbus poll plan, reporting interval and deep-sleep over USB or BLE, and read it back to confirm.

Free No install Chrome / Edge · USB / BLE

Launch configurator → All software

mesh.siliqs.net

Current node Sensor · relay

firmware v1.2.4 · reads Modbus, forwards on mesh

Role

Sensor (CLIENT)▾

Modbus poll

slave 1 · FC04 · reg 0 ×2 · every 60 s

Save settings

What it solves

One job: decide what a node does, without recompiling firmware or typing serial commands.

Who: The person deciding, in the field, what this node should do — an integrator or an app-savvy user, not a firmware developer.
The pain: “The board is alive, but should it be a gateway or a sensor? Which Modbus registers? How often? Deep sleep to save power? — I don’t want to recompile firmware or type serial commands to change these.”
What it removes: Editing firmware, serial-console commands, and having to remember which mode combination means what.
In → out: A node with firmware (USB/BLE) → (pick role, Modbus poll plan, deep-sleep sub-mode) → a node that knows its job, and reads its current config back so you can confirm it.
Done when: The node polls / reports on the mesh exactly per its config.

How it works

Connect the node

Over USB, or wirelessly over BLE — the page reads the node’s current mode and firmware version.

Pick role & settings

Gateway or sensor; the Modbus poll plan (slave, function, registers); reporting interval; deep-sleep sub-mode.

Save & read back

Write to the node, then read its config back — so you see the node’s real state and don’t misread it.